Written by
Julian Reyes Appliance Care EditorPublished October 26, 2026
VERIFIED
Error codeAll Cycle Status indicators flashing / beeping every 30 seconds
ApplianceDishwasher
Door not latched: the single entry
Row after row of Cycle Status lights blinking together, or a beep repeating every half minute, is one Problem Solver item in the Monogram booklet. It carries a single cause and a single remedy.
Listed cause
Listed remedy
The door has not been closed properly
Push the door in until it clicks into the latch
Nothing else is offered for this symptom, so no extra owner steps apply.
Is it your model?
The row is tagged for the ZBD5700 and ZBD5900, two dishwashers from an earlier Monogram generation. To confirm yours, find the model and serial numbers on the left flange inside the tub, where the booklet places them.
Door latched and the lights still blink or the beep carries on? Reach our San Francisco and Bay Area desk at (415) 318-7427. Have the model number and the fact that all status indicators are flashing ready, and see Monogram dishwasher repair for what we handle.
Model compatibility: Monogram reuses codes across series and model years, so All Cycle Status indicators flashing / beeping every 30 seconds may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
On ZBD5700 and ZBD5900 dishwashers, all Cycle Status lights flashing or a beep every 30 seconds is listed with a door that is not properly closed.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Monogram appliance?
Book a specialist visit for a clear estimate and approval before any repair.
Drain, fill, latch and cycle faults on Monogram dishwashers, with each flashing-light message linked and a written estimate first. Estimate comes first.
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your Monogram appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
